New Product

VERSAWRAP

- Install thin furring strips or shims to the structural column at the top, middle and bottom making sure the outside dimension of the furring strips are no larger than the inside dimensions of the column wrap. - Apply Weld-On 705, Christy’s Red Hot, Trim Tight or any PVC glue into the four joints using a plastic squeeze bottle with a thin plastic nozzle applicator. Remember to apply the adhesive to only one joint surface. - Once the glue is places in the VERSAWRAP joints, placed it around the post or column pushing the miter tongue and groove joint together. Secure the wraps to the post or column with stainless steel nails or screws. - Remove the joint tape no more than 4 hours after bonding the last joint. Leaving the tape on the column wrap and exposed to the UV rays of the sun will make it difficult to remove and could leave adhesive residue on the face of the wrap. - If specified, install base/cap wraps and moulding trim to complete VERSAWRAP column wrap.

Tips when Installing VERSAWRAP

- Use a plastic squeeze bottle with a thin, tapered nozzle applicator like a ktechup bottle. Apply adhesive to only one surface of mitered joint. - Use a soft rubber mallet or dead blow hammer to close the tongue and groove friction lock joint. - To remove the tape, pull it, away from the top before you start to pull it down the column. - Remove the tape from the joints in 4 hours or less.

~ Taken from VERSATEX website; www.versatex.com on 11/16/2011